Genie GS-1930 Operator's Manual page 42

Operator's Manual
Inspections
107 Press the drive function button.
108 Press and hold the function enable switch on
the control handle.
109 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
blue and yellow triangles on the control panel.
Result: The steer wheels should not turn in the
directions indicated by the blue and yellow
triangles.
110 Raise the platform.
Result: The platform should raise to 32 ft /
9.8 m and stop.
111 Fully lower the platform.
112 Press the outrigger function button.
113 Wait seven seconds for the outrigger function
enable to time out.
114 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: The outriggers should not retract.
40
115 Press the outrigger function button.
116 Move the control handle in the direction
indicated by the blue arrow.
Result: The outriggers should retract. The
individual outrigger indicator lights will turn
solid green as the corresponding outrigger
retracts.
117 Continue holding the control handle and the
foot switch (if equipped) until the outriggers are
completely retracted. Release the control
handle when all outrigger indicator lights turn
off. All functions are now restored.
Note: If the control handle or foot switch (if
equipped) are released too soon during retraction,
the outrigger indicator lights will flash green,
indicating the outriggers are not fully retracted.
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
Part No. T107026