Genie GS-1930 Operator's Manual page 60

Operator's Manual
Operating Instructions
To Position Outriggers (GS-3232 models)
To Extend Outriggers:
1 Press the outrigger function button.
On the LCD screen, a circle below
the outrigger function symbol will
turn on.
2 Machines equipped with foot switch: Press and
hold the foot switch and press and hold the
function enable switch on the control handle at
the same time.
3 Move the control handle in the direction
indicated by the yellow arrow.
The outriggers will begin to extend. The individual
outrigger indicator light will turn solid green as the
corresponding outrigger makes contact with the
ground. Continue moving the control handle until
the lift enable indicator light turns green and a
beep is heard. The machine is now level. When
the lift error indicator light turns red, the up/down
and drive functions are disabled. The lift error
indicator light will turn red under the following
conditions:

The platform is raised to 22 ft / 6.7 m and the
outriggers are not deployed.

Not all outriggers are in contact with the
ground.

All four outriggers are in contact with the
ground but the machine is not level.

Error code.
58
Note: If the outrigger enable and extend buttons
are released too soon during extension, the
outrigger indicator lights will continue to flash
green, indicating the outriggers are not contacting
the ground.
Note: If the outrigger lights are solid green, the
machine may not be level or the outriggers may
not be fully deployed if a long beep is not heard at
the platform controls alarm.
To Retract Outriggers:
1 Press the outrigger function
button.
2 Machines equipped with foot switch: Press and
hold the foot switch and press and hold the
function enable switch on the control handle at
the same time.
3 Move the control handle in the direction
indicated by the blue arrow.
Release the control handle once the outriggers are
off the ground. After approximately 5 seconds, the
outrigger indicator lights will turn off. All functions
are now restored.
Note: If the outrigger enable and retract buttons
are released too soon during retraction, the
outrigger indicator lights will flash green, indicating
the outriggers are not fully retracted.
GS-30 • GS-32 • GS-46 • GS-47
Sixth Edition • Ninth Printing
Part No. T107026