Adding The Description Of A Bfd Session - Huawei AR2200-S Series Configuration Manual

Huawei AR2200-S Series Enterprise Routers
Configuration Guide - Reliability
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd cfg-name
The BFD session view is displayed.
Step 3 Run:
wtr wtr-value
The WTR is configured.
By default, the WTR is 0.
----End

3.7.4 Adding the Description of a BFD Session

Descriptions of BFD sessions help you distinguish between different BFD sessions.
Context
Perform the following procedure on the router:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd cfg-name
The BFD session view is displayed.
Step 3 Run:
description description
The description of a BFD session is added.
Issue 01 (2012-01-06)
NOTE
l As a BFD session takes effect on a unidirectional path, the WTR time at both ends of the path must be
the same. If the WRT time on one end is different from that on the other end, applications on the two
ends detect different BFD status after the BFD status on one end changes.
l To modify a parameter after a BFD session has been created, run a corresponding command (such as
process-interface-status,min-tx-interval, min-rx-interval, detect-multiplier, tos-exp, wtr, or
description). The modification takes effect immediately without the commit command configured.
NOTE
The description command takes effect only on statically configured BFD sessions not on BFD sessions
that are dynamically configured or BFD sessions that are created by using automatically negotiated
discriminators.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BFD Configuration
160