Huawei AR2200-S Series Configuration Manual page 52

Huawei AR2200-S Series Enterprise Routers
Configuration Guide - Reliability
Configuration Files
l
l
Issue 01 (2012-01-06)
State
Run the undo shutdown command on GigabitEthernet2/0/0 of RouterB to make the
interface Up. After 10 seconds, run the display standby state command on RouterA. The
command output shows that the route status is OK and backup interface
GigabitEthernet2/0/0 has switched to the standby state.
<RouterA> display standby state
Interface
Loadstate
Backup-flag
meaning:
M---MAIN B---BACKUP
USED
D---LOAD P---
PULLED
----------------------------------------------------------------------------
Below is track BFD
information:
Bfd-Name
State
----------------------------------------------------------------------------
Below is track IP route
information:
Destination/Mask
State
4.1.1.0/24
STANDBY
----------------------------------------------------------------------------
Below is track NQA
Information:
Instance Name
Configuration file of RouterA
#
sysname RouterA
#
isis 1
is-level level-1
network-entity 10.0000.0000.0001.00
#
interface GigabitEthernet1/0/0
ip address 2.1.1.1 255.255.255.0
isis enable 1
#
interface GigabitEthernet2/0/0
ip address 3.1.1.1 255.255.255.0
standby track ip route 4.1.1.0 255.255.255.0
#
ip route-static 0.0.0.0 0.0.0.0 3.1.1.2
#
return
Configuration file of RouterB
#
sysname RouterB
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Interfacestate Backupstate Backupflag Pri
V---MOVED U---
Bfd-State BackupInterface
Route-State BackupInterface
OK GigabitEthernet2/0/0
BackupInterface
1 Interface Backup Configuration
State
44