Huawei AR2200-S Series Configuration Manual page 29

Huawei AR2200-S Series Enterprise Routers
Configuration Guide - Reliability
Figure 1-8 Networking diagram of interface backup in load balancing mode
192.168.1.0/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
1.
Issue 01 (2012-01-06)
GE1/0/0
2.2.2.1/24
GE2/0/0
1.1.1.1/24
RouterA
GE3/0/0
3.3.3.1/24
HostA
192.168.1.2/24
Configure GE2/0/0 as the primary interface on RouterA.
Configure GE1/0/0 and GigabitEthernet3/0/0 as backup interfaces of GE2/0/0 and set a
higher priority for GE1/0/0.
Set the maximum bandwidth of the primary interface and higher and lower thresholds.
Link attributes of interfaces
IP addresses and subnet masks of interfaces
Priorities of backup interfaces
Higher and lower thresholds and maximum bandwidth of the primary interface
Configure static routes.
# On RouterA, configure a static route to the network segment where HostB is located.
<Huawei> system-view
[Huawei] sysname RouterA
[RouterA] ip route-static 192.168.2.0 24 2.2.2.2
[RouterA] ip route-static 192.168.2.0 24 1.1.1.2
[RouterA] ip route-static 192.168.2.0 24 3.3.3.2
# On RouterB, configure a static route to the network segment where HostA is located.
<Huawei> system-view
[Huawei] sysname RouterB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Interface Backup Configuration
GE1/0/0
2.2.2.2/24
GE2/0/0
1.1.1.2/24
RouterB
192.168.2.0/24
GE3/0/0
3.3.3.2/24
HostB
192.168.2.2/24
21