Huawei AR2200-S Series Configuration Manual page 58

Huawei AR2200-S Series Enterprise Routers
Configuration Guide - Reliability
Configuration Files
l
Issue 01 (2012-01-06)
Instance Name
State
user
test
ERR
Run the undo shutdown command on GigabitEthernet1/0/0 of RouterB to make the
interface Up. After 10s, run the display standby state command on RouterA. The
command output shows that the route status is OK and backup interface Serial 1/0/0:15
has switched to the standby state.
<RouterA> display standby state
Interface
Loadstate
Backup-flag
meaning:
M---MAIN B---BACKUP
USED
D---LOAD P---
PULLED
----------------------------------------------------------------------------
Below is track BFD
information:
Bfd-Name
State
----------------------------------------------------------------------------
Below is track IP route
information:
Destination/Mask
State
------------------------------------------------------------------------------
--
Below is track NQA
Information:
Instance Name
State
user
test
OK
Configuration file of RouterA
#
sysname RouterA
#
controller E1
1/0/0
pri-set
#
interface Serial1/0/0:15
link-protocol ppp
ip address 3.1.1.1 255.255.255.0
dialer enable-circular
dialer-group 1
dialer route ip 3.1.1.2 600502
standby track nqa user test
#
dialer-rule
dialer-rule 1 ip permit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
BackupInterface
Serial 1/0/0:15
Interfacestate Backupstate Backupflag Pri
V---MOVED U---
Bfd-State BackupInterface
Route-State BackupInterface
BackupInterface
Serial 1/0/0:15
1 Interface Backup Configuration
UP
STANDBY
50