Replace The Parking Brake Lining (Electric Motor Brake) - Taylor-Dunn B0-248-36 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair
REPLACE THE PARKING BRAKE LINING
(ELECTRIC MOTOR BRAKE)
1. Remove the electric brake assembly from the drive. Refer to
Transmission
in the
2. Place the brake assembly on flat surface with the shaft pointing up.
3. Mark the orientation of the outer housing and
magnet. This mark will be used to correctly align
the housing during reassembly
4. Remove the three Allen head socket screws evenly
so that the internal spring pressure is reduced
gradually. Turn each screw no more than two turns
at a time.
5. Remove the outer housing and friction plate.
Current Taylor-Dunn
®
possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to appendix C for
recommended handling precautions.
section for information regarding removing the brake.
Brakes
brakes are asbestos free. However, there is the
Motor Removal and Installation
Page 12