Inspect The Parking Brake; Wheel Park Brake (Hydraulic Disc) - Taylor-Dunn B0-248-36 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

INSPECT THE PARKING BRAKE

Wheel Park Brake (hydraulic disc)

NOTE: The parking brake is actuated through a pin in the center of the
6. Release the park brake.
7. Inspect the brake pads. Refer to Inspect the
Service Brake section to inspect the brake pads.
8. Inspect the park brake pin and bushing for any signs
of damage or corrosion.
NOTE: The park brake pin is inside of the
9. Inspect all brake cables and linkages for any signs
of damage, wear, or missing cotter pins.
10. Inspect the brake handle locking mechanism for any
signs of damage.
NOTE: Refer to Adjust the Parking Brake
rear left and right brake body on the rear axles.
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
brake body. Refer to Repair the Brake
Body for information on removing the
park brake pin.
section for information regarding
adjusting the parking brake.
If any sign of damage or wear is found on the locking mechanism,
cables, or linkages then they must be repaired or replaced
immediately. Failure to repair or replace any damaged component
could result in failure of the park brake causing property damage
and/or severe bodily injury.
Brakes Page 4