Taylor-Dunn B0-248-36 Operation, T Roubleshooting And Replacement Parts Manual page 94

Maintenance, Service, and Repair
9. Remove the tire/wheel assembly.
NOTE: Refer to
the tire and wheel assembly.
10. Release the park brake (wheel brake only).
11. Remove the brake body bolts and discard the lock nuts and brake pads.
12. Remove the spacer bushings from the mounting
bracket and discard.
13. Inspect the brake rotor. Refer to
Service Brake
section for information regarding
inspecting the brake rotor.
14. Inspect the spacers and replace if any wear or
damage is found.
15. Install new spacer bushings in the mounting bracket.
16. Back off the parking brake adjustment (wheel park
brake only).
17. Install new brake pads in reverse order. Torque the
mounting bolts to 11 ft-lbs.
18. Repeat this procedure for the other wheel.
19. Install the tire/wheel assembly and lower the vehicle to the ground.
20. Fill the master cylinder to the proper level. Refer to
for information regarding the correct master cylinder fluid level.
21. Adjust the parking brake (wheel park brake only). Refer to
22. Set the park brake.
23. Reconnect the main positive and negative cables at the batteries.
24. Remove the blocks from behind the wheels.
25. Release the park brake and test drive the vehicle.
Tires and Wheels
section for information on removing
Inspect the
R
Brakes Page 18
Check Master Cylinder Fluid
Adjust the Parking Brake
section
section.