Taylor-Dunn B0-248-36 Operation, T Roubleshooting And Replacement Parts Manual page 27

SAFETY RULES AND OPERATING INSTRUCTIONS
Display showing Maintenance and
Wrench icons
Maintenance Monitor:
NOTE: The Maintenance Monitor function is optional.
The Maintenance Monitor function can be
turned ON or OFF by your dealer.
Operation: The SMD notifies the operator 10-hours
(standard) before a scheduled maintenance is due.
During this warning period, the meter will continue to
alert the operator. This should allow sufficient time for
the operator to schedule the maintenance that is due,
with minimal down time. If the scheduled maintenance
is not performed before the warning period elapses, then
the vehicles maximum speed will be significantly
reduced.
Warning period: The warning starts when the
Maintenance Indicator is ON and the Wrench icon is
flashing. The Wrench icon will continue to flash until the
warning time has expired.
Maintenance Due: Once the warning has expired and
the maintenance is due, the Wrench icon will stop
flashing and remain ON. Additionally, the vehicles
maximum speed will be significantly reduced until the
maintenance is performed and the display is reset. The
display should only be reset by an authorized technician.
Illustrated parts
Refer to the
regarding tools required to reset the Smart View Display.
Speed controller status: The display will indicate a fault
code whenever the control system logic detects a
problem with the control system. A fault code is being
displayed whenever the Fault Code Indicator (the letter
'F') is visible at the left of the numeric display. Refer to
the fault code table in this section for a summery
description of the fault codes.
section for information
Safety Rules
Page 13