If cable accommodation is required, rout the power cable and/or Eth cable through either of
Step 3.
the outer rails.
Secure the switch to the left and right inner rails (A+B), by gently pushing the switch chas-
Step 4.
sis' pins through the slider key holes, until locking occurs.
Secure the chassis in the inner rails screwing the 2 flat head Phillips screws (F) in the desig-
Step 5.
nated points with a torque of 1.5±0.2 Nm.
Slide the switch into the rack by carefully pushing the inner rails into the outer rails installed
Step 6.
on the rack.
Rev. 1.7
Figure 15: Attaching the Inner Rails to the Chassis
Figure 16: Securing the Chassis in the Inner Rails
Mellanox Technologies
Installation
26