Figure 27: Power Status Led; Figure 28: Rear Side Panel; Table 16: Power Supply Unit Status Front Led Assignments - Mellanox Technologies SB7700 User Manual

4.2.1.3 Power Supply Status LEDs
There are two power supply inlets in the system (for redundancy). The system can operate with
only one power supply connected. In case the power supply is an FRU, a second power supply
unit can be added to support hot-swap ability. Each power supply unit has a single 2 color LED
on the right side of the unit, that indicates the status of the unit.
The primary power supply (PS) unit is located on the left side and the secondary unit is located
on the right side.
Table 16 - Power Supply Unit Status Front LED Assignments
LED Behavior
Solid green
Solid amber
Off
Rev. 1.7

Figure 27: Power Status LED

Figure 28: Rear Side Panel

Description
All plugged (one or two) power supplies
are running normally.
One or both of the power supplies are
not operational or not powered up/ the
AC power cable is disconnected
N/A
Mellanox Technologies
Action Required
N/A
Make sure the AC cable is plugged
in and active. If the problem
resumes, the FRUs might be faulty,
and should then be replaced.
N/A
Interfaces
47