Mellanox Technologies SB7700 User Manual page 63

14. Equipment Disposal
Disposal of this equipment should be in accordance to all national laws and regula-
tions.
15. Local and National Electrical Codes
This equipment should be installed in compliance with local and national electrical
codes.
16. Installation Codes
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electri-
cal Code.
17. Battery Replacement
Warning: Replace only with UL Recognized battery, certified for maximum abnormal
charging current not less than 4mA
There is a risk of explosion should the battery be replaced with a battery of an incorrect
type.
Dispose of used batteries according to the instructions.
18. UL Listed and CSA Certified Power Supply Cord
and CSA Certified, 3 - conductor, [16 AWG], terminated with a molded plug rated at
125 V, [13 A], with a minimum length of 1.5m [six feet] but no longer than 4.5m.
For European connection, select a power supply cord that is internationally
harmonized and marked "<HAR>", 3 - conductor, minimum 1.0 mm2 wire, rated at
300 V, with a PVC insulated jacket. The cord must have a molded plug rated at 250 V,
10 A.
19. Installation codes
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electri-
cal Code.
20. Interconnection Of Units
Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certified
type DP-1 or DP-2. (Note- when residing in non LPS circuit)
Rev. 1.7
For North American power connection, select a power supply cord that is UL Listed
Mellanox Technologies 63