Mounting The Cpu/Interface Module - Siemens Simantic ET200SP System Manual

Installation

4.3 Mounting the CPU/interface module

4.3 Mounting the CPU/interface module
Introduction
The CPU/the interface module connects the ET 200SP distributed I/O system to the fieldbus
and exchanges the data between the higher-level control system and the I/O modules /
motor starters.
Requirement
The mounting rail is fitted.
Required tools
3 to 3.5 mm screwdriver (only for mounting and removing the BusAdapter)
Mounting the CPU/interface module
Watch the video sequence (http://support.automation.siemens.com/WW/view/en/95886218)
To install a CPU/interface module, follow these steps:
1. Install the CPU/interface module on the mounting rail.
2. Swivel the CPU/interface module towards the back until you hear the mounting rail
release button click into place.
Figure 4-2
60
Mounting the CPU/interface module
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG