Identification And Maintenance Data; Reading Out And Entering I&M Data - Siemens Simantic ET200SP System Manual

Reference
You will find the setup of the parameter data record in the manuals of the I/O modules
(http://support.automation.siemens.com/WW/view/es/55679691/133300).
10.9

Identification and maintenance data

10.9.1 Reading out and entering I&M data
I&M data
I&M identification data is information which is stored on the module either as read-only data
(I-data) or read/write data (M-data).
Identification data (I&M0): Manufacturer information about the module that can only be read
and is in part also printed on the housing of the module, for example, article number and
serial number.
Maintenance data (I&M1, 2, 3): Plant-dependent information, e.g. installation location.
Maintenance data is created during configuration and written to the module.
All modules of the ET 200SP distributed I/O system support identification data (I&M0 to
I&M3).
The I&M identification data supports you in the following activities:
● Checking the plant configuration
● Locating hardware changes in a plant
● Correcting errors in a plant
Modules can be clearly identified online using the I&M identification data.
STEP 7 allows you to read the identification I&M data (see STEP 7 online help).
Note
The BusAdapter and the interface module IM 155-6 PN HF support the identification data
I&M0 to I&M4 (signature).
Options for reading out I&M data
● Via the user program
● Using STEP 7 or HMI devices
● Via the Web server of the CPU
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
10.9 Identification and maintenance data
Commissioning
221