Installing The Server Module - Siemens Simantic ET200SP System Manual

Installation

4.7 Installing the server module

4.7 Installing the server module
Introduction
The server module on the far right of the assembly/line completes the ET 200SP distributed
I/O system.
Requirement
The last BaseUnit is mounted.
Installing the server module
Watch "Install configuration" video sequence
(http://support.automation.siemens.com/WW/view/en/95886218)
Proceed as follows to install a server module:
1. Install the server module on the mounting rail on the right next to the last BaseUnit.
2. Swivel the server module backwards on the mounting rail.
3. Move the server module parallel to the left until you hear it click into the last preceding
BaseUnit.
Figure 4-6
Removing the server module
Proceed as follows to remove a server module:
1. Press the mounting rail release button on the server module.
2. Move the server module parallel to the right.
3. While pressing the mounting rail release button, swivel the server module off the
mounting rail.
68
Installing the server module
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG