Mounting The Interface Module - Siemens SIMATIC ET 200SP HA System Manual

Installation

5.4 Mounting the interface module

5.4 Mounting the interface module
Introduction
The interface module connects the IO device to the fieldbus and exchanges data between the
IO controller and the I/O modules.
Note
Scope of delivery (server module and power bus cover)
A server module and a power bus cover are supplied for the interface module with every carrier
module.
Requirement
The rail is fitted.
Tools required
● Screwdriver 3.5 mm or TORX T10 (recommended): Only for installation of the BusAdapter
● Screwdriver 4.5 mm or TORX T15 (recommended): For fastening the fixing screws to the
rail.
Mounting the interface module
To mount the interface module, proceed as follows:
Step
1
2
66
Procedure
Hang the carrier module (for assembling the interface
module) on the rail.
Note:
Take into consideration the required version of the car‐
rier module (redundant configuration/non-redundant
configuration)
There is a difference between IM (removable "module")
and the subrack module.
Swivel the carrier module backwards until you hear the
carrier module click into place on the rail.
Illustration
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD