Reset Command - Qlogic SANbox2-8c Installation Manual

B – Command Line Interface

Reset Command

Reset Command
Resets the switch configuration parameters. If you omit the keyword, the default is
Reset Switch.
Authority
Admin
Syntax
reset
config [config_name]
factory
port [port_number]
snmp
switch (default)
system
zoning
Keywords
config [config_name]
Resets the configuration given by [config_name] to the factory default values for
switch, port, alarm threshold, and zoning configuration. If [config_name] does not
exist on the switch, a configuration with that name will be created. If you omit
[config_name], the active configuration is reset. You must activate the
configuration for the changes to take effect. Refer to
for switch, port, and alarm threshold configuration default values.
factory
Resets switch configuration, port configuration, alarm threshold configuration,
zoning configuration, SNMP configuration, system configuration, and zoning to
the factory default values. The switch configuration is activated automatically.
Refer to
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning
with 0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table B-7
switch
Resets the switch without a power-on self test. This reset disrupts traffic and
activates the pending firmware. This command also closes all management
sessions. This is the default. To reset the switch with a power-on self test, refer to
the "Hardreset Command" on page
traffic, refer to the
system
Resets the system configuration settings to the factory default values. Refer to
Table B-8
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
B-22
Table B-3 through Table
for SNMP configuration default values.
"Hotreset Command" on page
for system configuration default values.
Table B-3
B-8.
B-12. To reset the switch without disrupting
B-15.
D
through Table B-6
59042-03 A