Black & Decker V1999 Instructions Manual page 7

a crevice tool (5) for confined spaces

a brush tool (6) for furniture and

stairs
To fit an accessory, proceed as follows:
Take the accessories from the

appliance.
Insert the appropriate accessory into

the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Slide the crevice tool into the brush.

Push the accessories down until they

click into place.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the
implementation of safety devices, certain
residual risks cannot be avoided. These
include:
Injuries caused by touching any

rotating/moving parts.
Injuries caused when changing any

parts, blades or accessories.
Injuries caused by prolonged use of

a tool. When using any tool for
prolonged periods make sure you
take regular breaks.
Impairment of hearing.

Health hazards caused by breathing

dust developed when using your tool
(example:- working with wood,
especially oak, beech and MDF).
Use
The appliance can be charged while

placed on a worktop or hung on the
wall using the wall hook provided.
The wall hook is not provided with
V1999 and V1999N.
Before first use, the battery must be

charged for at least 24 hours.
Leave the appliance connected to

the charger whenever it is not in use.
ENGLISH
Charging the battery (fig. A)
Make sure that the appliance is

switched off. The battery will not be
charged with the on/off switch in the
on position.
Insert the charger plug (8) into the

charger connector (9) at the rear of
the appliance.
Plug in the charger (7).

Switch on at the mains.

Leave the appliance to charge for at

least 24 hours.
Whilst charging, the charger may

become warm. This is normal and
does not indicate a problem. The
appliance can be left connected to
the charger indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 10°C or
above 40°C.
Switching on and off (fig. D)

To switch on, slide the on/off switch

(1) forward.
To switch off, slide the on/off switch

back.
Cleaning and maintenance
Warning! Regularly clean the filters.
Cleaning the dust bowl and filters (fig.
E & F)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and

remove the dust bowl (3).
Empty the dust bowl.

Remove the filter assembly (10) by

twisting it clockwise.
Wash the filters in warm, soapy

water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and filters

are dry.
Refit the filter assembly (10) onto the

appliance, twisting it
counterclockwise until it locks into
place.
Refit the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place.
7