Download Print this page

Black & Decker V1999 Instructions Manual page 6

Hide thumbs

Advertisement

Table of Contents
ENGLISH
When disposing of batteries, follow
the instructions given in the section
"Protecting the environment".
Do not damage/deform the battery
pack either by puncture or impact, as
this may create a risk of injury and
fire.
Do not charge damaged batteries.
Under extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge non-
rechargeable batteries.
If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker
Service Centre in order to avoid a
hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
6
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Read all of this manual
carefully.
Your charger is double
insulated; therefore no earth
wire is required.
Fail-safe isolating
transformer. The mains
supply is electrically
separated from the
transformer output.
The charger automatically
o
130
C
shuts off if the ambient
temperature becomes too
high. As a consequence the
charger will be inoperable.
The charging base must be
disconnected from the mains
supply and taken to an
authorised service centre for
repair.
The charging base is
intended for indoor use only.
Features
1. On/off switch
2. Release button
3. Dust bowl
4. Hanging loop
Fig. A
5. Crevice tool (V2401/V2405/V3605/
V4890C/V4890CN/V4899/V6090C)
6. Brush tool (V2401/V2405/V3605/
V4890C/V4890CN/V4899/V6090C)
Assembly
V2401/V2405/V3605/V4890C/V4890CN/
V4899/V6090C -
Fitting the accessories (fig. A & B)
These models are supplied with the
following accessories:

Advertisement

Table of Contents
loading

  Related Manuals for Black & Decker V1999