S12 Terminal; S1–S4 Terminal Delay; S2/3 Terminal - Toshiba Q7 Installation And Operation Manual

S12 Terminal

S12 Terminal
Program Input Terminals
This parameter selects the functionality of the S12 discrete input terminal.
Note: The S12 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S12 terminal
assignment information will be stored in volatile memory.
The terminal assignment information will be lost if the
system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S12 terminal to 1 of the 69 possible
functions that are listed in
S1–S4 Terminal Delay
Program Terminal Delays
This parameter delays the response of the ASD to any change in the S1–S4
terminal input by the programmed value (see waveforms at
The delay may be increased to provide additional electrical noise immunity or
to prevent the ASD from responding to contact bounce or chatter.
S2 Terminal
Program Input Terminals
This parameter selects the functionality of the S2 discrete input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S2 terminal to 1 of the 69 possible
functions that are listed in
S3 Terminal
Program Input Terminals
This parameter selects the functionality of the S3 discrete input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S3 terminal to 1 of the 69 possible
functions that are listed in
112
S12 Terminal
Table 7 on page 130.
S1–S4 Delay
S2 Terminal
Table 7 on page 130.
S3 Terminal
Table 7 on page 130.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Parameter Type — Numerical
Factory Default — 8.0
FL Off Delay).
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Parameter Type — Selection List
Factory Default — Preset Speed Cmd #2
Changeable During Run — No
Parameter Type — Selection List
Factory Default — Damper Fdbk
Changeable During Run — No
Q7 ASD Installation and Operation Manual
S3 Terminal