Asd Number; Asd Switching Wait Time; Asd Typeform; Autotune Control - Toshiba Q7 Installation And Operation Manual

ASD Number

ASD Number
Program Comm Settings
This parameter plays a role in the setup of the communications network by
assigning an identification (ID) number to each ASD in the communications
network.
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or
modifies the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Note: Valid address numbers for this parameter are 1–247. The
default setting is 0. The default setting must be changed to a
valid setting to use this parameter. Otherwise an Invalid
Address error is returned.

ASD Switching Wait Time

Program Utility Group
This parameter determines the amount of time that the drive will wait before
outputting a signal to the motor once the switch-to-drive-output criteria has
been met.

ASD Typeform

Program Utility Group
This parameter is read-only and displays the current typeform configuration of
the ASD.

Autotune Control

Program Motor Settings
When enabled via the Autotune Enable
Autotune command status.
Settings:
(Autotune) Disabled
Reset (Motor) Defaults
Enable (Autotune) on Run Command
Q7 ASD Installation and Operation Manual
ASD Number
ASD Typeform
ASD Typeform
Autotune Control
parameter, this parameter sets the
Autotune Control
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 255
Parameter Type — Read-Only
Factory Default — (ASD-dependent)
Changeable During Run — No
Parameter Type — Read-Only
Factory Default — (ASD-dependent)
Changeable During Run — No
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
49