S1 Terminal; S10 Terminal; S11 Terminal - Toshiba Q7 Installation And Operation Manual

S1 Terminal

S1 Terminal
Program Input Terminals
This parameter selects the functionality of the S1 discrete input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S1 terminal to 1 of the 69 possible
functions that are listed in

S10 Terminal

Program Input Terminals
This parameter selects the functionality of the S10 discrete input terminal.
Note: The S10 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S10 terminal
assignment information will be stored in volatile memory.
The terminal assignment information will be lost if the
system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S10 terminal to 1 of the 69 possible
functions that are listed in

S11 Terminal

Program Input Terminals
This parameter selects the functionality of the S11 discrete input terminal.
Note: The S11 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S11 terminal
assignment information will be stored in volatile memory.
The terminal assignment information will be lost if the
system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S11 terminal to 1 of the 69 possible
functions that are listed in
Q7 ASD Installation and Operation Manual
S1 Terminal
Table 7 on page 130.
S10 Terminal
Table 7 on page 130.
S11 Terminal
Table 7 on page 130.
S11 Terminal
Parameter Type — Selection List
Factory Default — Fire Speed
Changeable During Run — No
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
111