Units For Voltage And Current; Upper Deviation Limit; Upper Limit Frequency; User Unit #1 / User Unit #2 – 5 - Toshiba Q7 Installation And Operation Manual

Units for Voltage and Current

Units for Voltage and Current
Program Utility Group
This parameter sets the unit of measurement for current and voltage values
displayed on the keypad.
Settings:
%
V/A

Upper Deviation Limit

Program Feedback Settings
This parameter determines the maximum amount that the feedback may
increase the output signal.

Upper Limit Frequency

Program Fundamental #1
This parameter sets the highest frequency that the ASD will accept as a
frequency command or frequency setpoint. The ASD may output frequencies
higher than the Upper Limit Frequency (but, lower than the Maximum
Frequency) when operating in the PID Control mode, Torque Control mode,
or the Vector Control modes (sensorless or feedback).
Note: This setting may not be higher than the Maximum
Frequency setting.
User Unit #1
Program Utility Group
The displayed unit of measurement may be changed from the Hz default setting
to any of the available characters for the frequency-display screen.
User Unit #2 – 5 may be used to complete the unit of measurement display.
Note: Program Utility Group
a non-zero value to use this feature.
User Unit #2 – 5
Program Utility Group
See User Unit #1 for information on this parameter.
Q7 ASD Installation and Operation Manual
Units for V/I
Upper Dev Limits
Upper Limit Freq
User Unit #1
Frequency Multiplier must be
User Unit #2 – 5
User Unit #2 – 5
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
Parameter Type — Numerical
Factory Default — 50.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Parameter Type — Numerical
Factory Default — 60.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq.
Units — Hz
Parameter Type — Alpha-Numeric
Factory Default — None
Changeable During Run — Yes
125