Communications Speed #1/2; Commercial Power Wait Time; Cooling Fan Control; Cpu Revision - Toshiba Q7 Installation And Operation Manual

Communications Speed #1
Communications Speed #1
Program Comm Settings
This parameter is used to set the gain and bias of the Communications
Reference speed control input.
See Communications Reference #1
This parameter sets Communications Speed #1.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Communications Speed #2
Program Comm Settings
This parameter is used to set the gain and bias of the Communications
Reference speed control input.
See Communications Reference #1
This parameter sets the Communications Speed #2.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.

Commercial Power Wait Time

Program Special Controls
This parameter determines the amount of time that the drive will wait before
allowing commercial power to be applied to the motor once the switch-to-
commercial-power criteria has been met.

Cooling Fan Control

Program Protection
This parameter sets the cooling fan run-time command.
Settings:
Automatic
Always On

CPU Revision

Program Utility Group
This is a read-only parameter that displays the revision level of the CPU.
56
Comm Speed 1
for further information on this setting.
Comm Speed 2
for further information on this setting.
Comm Wait Time
Cooling Fan Ctrl
CPU Revision
CPU Revision
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq.
Units — Hz
Parameter Type — Numerical
Factory Default — 80.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq.
Units — Hz
Parameter Type — Selection List
Factory Default — 0.62
Changeable During Run — No
Minimum — 0.37
Maximum — 10.00
Units — Seconds
Parameter Type — Selection List
Factory Default — Automatic
Changeable During Run — Yes
Q7 ASD Installation and Operation Manual