Connection Outline For Connection Cables (Example: Cc-Link/Lt Dedicated Flat Cables); How To Attach Connectors For The Dedicated Flat Cable (Terminal/T-Branch Processing) - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
9.8.2 Connection outline for connection cables (Example: CC-Link/LT dedicated flat
cables)
This subsection explains how to connect CC-Link/LT dedicated flat cables.
1) The connection cable connection order has no relevance to the station number.
2) Make sure to place the CC-Link/LT built-in master on one end of the trunk line.
Connect a terminating resistor for the CC-Link/LT built-in master within 20cm from a connector.
3) Make sure to connect a terminating resistor on each end of the CC-Link/LT trunk line.
Connection example for the CC-Link/LT dedicated flat cable
Connect the dedicated flat cable to a T branch or remote I/O unit using dedicated flat cable connectors.
T-branch area
Connector for dedicated
flat cable
Connection area (built-in master, remote station, power supply)
9.8.3 How to attach connectors for the dedicated flat cable (terminal/T-branch
processing)
This paragraph explains how to attach connectors for the dedicated flat cable.
1. Components
The components are as shown below.
Component 1 : Cover
Pressure-welding tool
for the communication connector
L-TOON-N
9 CC-Link/LT Built-in master ability (Only FX3UC-32MT-LT)
9.8 Connection of Cables, Connectors and Terminating Resistors
Built-in master
Power adapter
Terminal block type
remote module
Sensor connector type
remote module
MIL connector type remote
I/O module
Connector for dedicated
flat cable
Component 2 : Body
Connector for dedicated
flat cable
Connector for dedicated
flat cable
Connector for dedicated
flat cable
Component 3 : Dedicated flat cable
Cable type remote
I/O module
Orange
273
1
2
3
4
5
6
7
8
9
10