Connecting A Connection Cable To The Cc-Link/Lt Interface Connector; How To Attach A Terminating Resistor - Mitsubishi FX3UC SERIES User Manual

FX Series Programmable Controllers
3UC
User's Manual - Hardware Edition
9.8.6

Connecting a connection cable to the CC-Link/LT interface connector

1. Connection procedure
Connect a connection cable to the CC-Link interface connector
( in right figure).
9.8.7

How to attach a terminating resistor

This paragraph explains how to attach terminating resistors to either end of the CC-Link/LT system.
Attach a terminal resistor to the cable connector.
Caution:
The following example shows attachment to a CC-Link/LT dedicated cable.
Use the same method for a VCTF cable or high flexible cable.
→ For details on the terminating resistor attachment method for the built-in master when using
1. How to attach a terminating resistor on the FX
Connect a terminating resistor in a position within 200mm (7.87") from the CC-Link/LT interface connector.
FX -32MT-LT
3UC
Within 200mm (7.87") from the CC-Link/LT
interface connector
2. How to attach a terminating resistor on the trunk line side
The method to attach a terminating resistor on the opposite side of the FX
shown below.
Orange
Dedicated flat cable
connector
9 CC-Link/LT Built-in master ability (Only FX3UC-32MT-LT)
9.8 Connection of Cables, Connectors and Terminating Resistors
a VCTF or high flexible cable as the trunk line, refer to Subsection 9.5.3.
3UC
Dedicated flat cable
connector
Orange
Terminating resistor
-32MT-LT built-in master side
Terminating resistor
-32MT-LT built-in master is
3UC
1
2
3
Connection
cable
4
5
6
7
8
9
10
279