Setting The Handset And Receiver Relationship; Checking The Ignition Operation; Gas Supply Connection; Preparing Appliance For Installation - Valor 762 Installer And Owner Manual

INSTALLER GUIDE

9.3 Setting the handset and receiver relationship.

The receiver will have to be set to learn the handset / remote code. Do this as below:
Place the 'ON/OFF' switch to the '-' (On position). This is on the right hand front of the
appliance.
Press and hold the reset button on the receiver (See figure 10) until you hear two (2)
acoustic signals. After the second, longer acoustic signal, release the reset button.
Within the subsequent 20 seconds press the (small flame) button on the handset
until you hear an additional long signal confirming the code is set (Please inform the
customer that this is a one time setting as is NOT required when changing batteries in
the handset or receiver).

9.4 Checking the ignition operation.

Simultaneously press and hold the 'OFF' and (large flame) buttons until a short
acoustic signal confirms the start sequence has begun; release buttons.
Continuing signals confirms the ignition is in progress. There will be a slight delay and
several sparks should be seen between the electrode and pilot tip (See figure 11).
On sensing a flame is not present the burner unit will shut off. If there are no sparks
check the following:
Ensure that the electrode lead is connected to the terminal at the base of the
electrode.
If the above is correct, check for damage to the electrode lead.

10. GAS SUPPLY CONNECTION

The fire is designed for a rear concealed connection only.
A nut and olive are provided for an 8mm pipe inlet connection to the 'T' connector at
the bottom front of the appliance. The 'T' connector can be rotated to allow
connection and includes a valve for isolating the gas supply and a pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used. Before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the convection box and run to the 'T'
connector at the front. The pipe run from the supply line up to the rear opening in the
convection box must be kept away from the area which will be taken by the
convection box when it is installed (See figure 5).
Note that the centre of the appliance inlet 'T' connector is 25mm above the fireplace
floor. The inlet 'T' connector should be fitted to the supply pipe at this stage.

11. PREPARING APPLIANCE FOR INSTALLATION

1. Detach the burner unit and support tray from the convection box by removing six
screws (See figure 12). Lift the burner unit clear.
©
Page 22
GDC Group Ltd. 2013