Configure The Settings Relating To The Output Terminal [Alarm]; S22X1 S21X1; S25X1 S22X1 S21X1 - Panasonic WV-S2500 Series Operating Instructions Manual

2 Settings
[Alarm deactivation time]
Configure the duration that detections won't be made after an alarm is detected. For example, by using this
function you can prevent E-mail from being sent too often when E-mail notifications are configured to be sent
to cellular phones when an alarm is detected.
5-600s
•
Default: 5s
Note
•
The duration that alarm detections are not made can be managed for each type of alarm. For example,
during the time when detections for command alarms are not made, detections for VMD alarm can be
made.
2.7.2 Configure the settings relating to the output terminal
[Alarm]
S11x2
Click the [Alarm] tab on the "Alarm" page. (®page 41, page 42)
The settings relating to the output terminal can be configured in this section.
Output terminal
In order to be able to configure "Output terminal", "Alarm output" must be selected for [Terminal 2] of the
[Alarm] setting.
[Terminal output upon alarm detection]
Select "On" or "Off" to determine whether or not to output the alarm signals to the output terminal when an
alarm is detected.
•
Default: Off
[SD memory card error]
Select "On" or "Off" to determine whether or not to output signals from the output terminal when an error is
detected for the SD memory card.
SD memory card error condition: SD memory card error (write error, read error, etc), Total use time over 6
years, and number of overwrites over 2000 times
•
On: When an error status is detected, the signals from an output terminal is outputted and the [Alarm
occurrence indication] button on the "Live" page blinks.
•
Off: Deactivates the warning status detection.
•
Default: Off
IMPORTANT
•
In order to be able to correctly use this function, format the SD memory card with the camera before
using it.
128 Operating Instructions
S11x1 S15x1 S25x1 S22x1 S21x1