Panasonic WV-S2500 Series Operating Instructions Manual page 15

Note
•
The following settings may be required.
Open Internet Explorer, click [Tools] ® [Internet Options] ® [Security] ® [Trusted Sites] ®
[Sites]. Register the camera address on [Website] of the displayed trusted windows. After
registration, close the web browser, and then access the camera again.
•
When it takes longer than the specified period to obtain the snap shot picture due to the network
environment, the snap shot picture may not be displayed.
•
If the image capture size specified for JPEG cannot be obtained, JPEG images are displayed with
the image capture size that could be obtained.
Therefore, when JPEG images obtained with snap shot are displayed on a PC, the displayed image
size may differ from the captured sized.
Mic input button
S11x2
Turns on/off the audio reception (hear audio from the camera on a PC). This button will be displayed only
when "Mic input", "Interactive(Full-duplex)", or "Interactive(Half-duplex)" is selected for "Audio transmission
mode" on the setup menu. (®page 120)
When the audio reception is turned off, the button will turn into the
will not be heard.
Audio volume can be adjusted (Low/ Middle/ High) by moving the volume cursor
Note
•
When "Audio volume control mode" is set to "Adjust Mic input" in the setup menu, the volume cursor
is not displayed when using "Audio recording" or "Audio detection".
•
When the camera is restarted, the adjusted volume level (for the reception) will return to the level
that had been set on the [Audio] tab on the setup menu. (®page 120)
•
Actual volume level will change in three steps even though the volume cursor can be adjusted
minutely.
Audio output button
Turns on/off the audio transmission (play audio from the PC on the unit speaker). This button will be
displayed only when "Audio output", "Interactive(Full-duplex)" or "Interactive(Half-duplex)" is selected for
"Audio transmission mode" on the setup menu. (®page 120)
The button will blink during the audio transmission. When the audio transmission is turned off, the button
display will switch to the
Audio output volume can be adjusted (Low/Middle/High) by moving the volume cursor
Note
•
When a user is using the audio transmission function with "Interactive(Half-duplex)" selected, the
receiver button and the transmission button will be inoperable for the other users. When
"Interactive(Full-duplex)" is selected, the transmission button is inoperable for other users.
•
The maximum duration of a single audio output is the audio output duration set in the [Audio] tab
on the "Image/Audio" page. Audio output stops when the specified audio output duration has
passed. To turn the audio transmission function on, click the [Audio output] button again.
•
When the camera is restarted, the adjusted volume level (for both the audio transmission and
reception) will return to the level that had been set on the [Audio] tab on the "Image/Audio" page.
(®page 120)
•
Actual volume level will change in three steps even though the volume cursor can be adjusted
minutely.
SD recording status indicator
The status of the SD recording can be checked with this indicator.
When the SD recording starts, the SD recording status indicator will light red. It will go off when the SD
recording stops.
S11x1 S15x1
S11x2 S11x1 S15x1
, and audio from the PC will not be heard.
S11x2 S11x1
S25x1 S22x1 S21x1
button and audio from the camera
S25x1 S22x1
S15x1 S25x1
1 Operations
S21x0
.
S21x1
.
S22x1 S21x1
Operating Instructions 15