Configure The Settings Relating To The Alarm Output Terminal [Alarm] - Panasonic WV-SW550 Series Operating Instructions Manual

13 Configure the alarm settings [Alarm]
H.264 recording (SD memory card)
[Pre alarm]
Determine whether or not to perform the pre alarm recording. When "Use" is selected, approx. 1 MB image
data is always saved during the pre alarm recording.
Use/ Not use
•
Default: Not use
[Post alarm (recording) duration]
Set the duration to save image data on the SD memory card after an alarm occurrence.
10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s
•
Default: 30s
* The actual recording time may sometimes be longer than the duration selected for this setting.
[Recording (memory) size per an alarm]
The capacity of the SD memory card used to record video data upon an alarm occurrence. The actual capacity
may be different.
IMPORTANT
•
To record H.264 data, it is required to select "Use" for "SD memory card" on the [SD memory card] tab.
In addition, it is required to select "H.264(1)" or "H.264(2)" for "Recording format". (®page 50)
13.4 Configure the settings relating to the alarm
output terminal [Alarm]
Click the [Alarm] tab on the "Alarm" page. (®page 40, page 42)
The settings relating to the alarm output terminal can be configured in this section.
Alarm output terminal setup
[Alarm output trigger]
Select "On" or "Off" to determine whether or not to output the alarm signals to the alarm output terminal when
an alarm is detected.
•
Default: Off
[Alarm output type]
Select "Latch" or "Pulse" for the alarm output terminal at an alarm occurrence.
•
Latch: When an alarm is detected, the alarm output terminal will be in the state selected for "Trigger
output" until the alarm occurrence indication button is clicked.
112 Operating Instructions