Settings Data/Backing Up Or Restoring Logs [Data] - Panasonic WV-S2500 Series Operating Instructions Manual

2 Settings
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
Note
•
To initialize the network settings (®page 152), turn off the power of the camera, then turn on the power
again while holding down the INITIAL SET button on the unit, and keep pressing the INITIAL SET
button for 10-15 seconds. Wait about 2 minutes after releasing the button. The camera will start up and
the settings including the network settings will be initialized. Do not turn off the power of the unit about
3 minutes after turning on the power.
•
The notification function allows users to provide the notification of the error to the specified destination
E-mail address and an original alarm destination when an error such as no SD memory card insertion
after the reboot or a locked SD memory card insertion occurs. (®page 157, page 142)

2.12.5 Settings data/backing up or restoring logs [Data]

Click the [Data] tab of the "Maintenance" page. (®page 41, page 42)
The settings related to backing up or restoring settings data, and saving logs can be configured in this section.
212 Operating Instructions