Panasonic WV-S2500 Series Operating Instructions Manual page 205

•
Off: Does not display items related to RS485 transmission.
•
Default: Off
[Command table - Upload]
When using RS485 control commands other than Pelco-D/Pelco-P, select "Custom" for "Protocol" and upload
the command table to the unit. The unit must be rebooted after the upload is completed.
Refer to the Panasonic website (http://security.panasonic.com/support/info/) for further information about how
to upload command tables and cases where RS485 cannot control cameras.
Command table settings are initialized when the unit is initialized. In this case, upload the command tables
again as necessary.
2 Settings
Operating Instructions 205