S11X2 S11X1 S151X S25X1 - Panasonic WV-S2500 Series Operating Instructions Manual

IMPORTANT
•
If the [AGC (audio)] setting is changed after configuring [Audio detection], the volume of the sound that
is detected with [Audio detection] may change. In this case, make sure to check the [Audio detection]
setting.
[Audio bit rate]
Set the audio compression bit rate.
[G.726(Live)]: 16kbps/32kbps
[G.711(Live)]: 64kbps (cannot be changed)
[AAC-LC(Live/Recording)]: 64kbps/96kbps/128kbps
•
Default:
–
[G.726(Live)]: 32kbps
–
[AAC-LC(Live/Recording)]: 128kbps
Audio transmission/reception
[Audio transmission mode]
Select the communication mode used for audio data transmission/reception between the camera and the PC
from the following:
•
Off: Does not receive/transmit audio between the camera and the PC.
•
Mic Input (To PC): PC receives the audio data from the camera. On the PC, the image can be viewed
together with the accompanying audio. The image and audio are not synchronized.
•
Audio output(From PC)
from the PC to the camera. Audio can be heard from the speaker connected to the camera.
•
Interactive(Half-duplex)
transmission are available. However, audio data cannot simultaneously be transmitted and received.
•
Interactive(Full-duplex)
transmission are simultaneously available.
•
Default: Off
Note
•
Howling may be generated depending on the usage conditions. Prevent sound generated by the PC
from entering the PC microphone.
•
When "Multicast" is selected for "Transmission type" on the [Image] tab of the "Image/Audio" page,
audio output will become unavailable while monitoring H.265 or H.264 images. To perform audio
output, click the [JPEG] button on the "Live" page.
•
If you have set the "Audio out" to "Monitor", you can only set the "Audio transmission mode" to "Off" or
"Mic Input (To PC)".
•
"Audio recording" and "Audio detection" are not available when "Interactive(Half-duplex)" is selected
for "Audio transmission mode".
[Mic input interval (Camera to PC)]
Select an interval for audio reception from the following.
20ms/ 40ms/ 80ms/ 160ms
•
Default: 40ms
Note
•
When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
S11x2 S11x1 S151x
S11x2 S11x1 S151x
S11x2 S11x1 S151x
S151x S25x1 S22x1
S25x1 S22x1 S21x1
S25x1 S22x1 S21x1
S25x1 S22x1 S21x1
S21x1
2 Settings
: Transmits audio data
: Both reception and
: Both reception and
Operating Instructions 121