Panasonic WV-S2500 Series Operating Instructions Manual page 50

2 Settings
Alarm
[Terminal 1]
Determine how to use terminal 1.
•
Off: Not used.
•
Alarm input(TRM1): Receives terminal alarm input.
–
Close: An alarm is detected when the terminal status is changed to "On".
–
Open: An alarm is detected when the terminal status is changed to "Off".
•
Black & white input: Receives the black & white input. (When the input is set to "On", the black & white
mode is activated)
•
Auto time adjustment: Receives time setting through terminal input. When the signal is entered, if the
time difference from the hour (every hour) is less than 29 minutes, the time is adjusted to 00 minutes 00
seconds. The time is not changed in operations which reset the time under 5 seconds. If you select auto
time adjustment, the pull-down menu to select close or open is displayed.
–
Close: Performs auto time adjustment when the terminal status is changed to "Close".
–
Open: Performs auto time adjustment when the terminal status is changed to "Open".
•
Default: Off
[Terminal 2]
Determine how to use terminal 2.
•
Off: Not used.
•
Alarm input(TRM2): Receives terminal alarm input.
–
Close: An alarm is detected when the terminal status is changed to "On".
–
Open: An alarm is detected when the terminal status is changed to "Off".
•
Alarm output: Alarm output will be carried out according to the settings for "Output terminal"
(®page 128).
•
Default: Off
[Terminal 3]
Determine how to use terminal 3.
•
Off: Not used.
•
Alarm input(TRM3): Receives terminal alarm input.
–
Close: An alarm is detected when the terminal status is changed to "On".
–
Open: An alarm is detected when the terminal status is changed to "Off".
•
AUX output: AUX output is carried out. The [AUX] button will be displayed on the "Live" page.
•
Default: Off
VMD alarm
•
On: If the VMD area is not configured, the entire region is configured. To configure the VMD area, use the
[VMD area] tab on the "Alarm" page. (®page 138)
•
Off: Disables all VMD states.
•
Default: Off
[Audio detection alarm]
•
On: If audio detection is not configured, set audio detection to "On". To set the sensitivity of audio detection,
set using the [Audio detection] tab on the "Alarm" page. (®page 140)
•
Off: Disables audio detection.
•
Default: Off
50 Operating Instructions