Delays - User Option - Notifier ID50 SERIES Operating Manual

ID50 Series Panel - Operating Manual

4.10.4 Delays - User Option

[U0 Disable/Enable]
4
Disable Delays
Press
5
[U0 Disable/Enable]
The Disable / Enable Delays option allows the user to
cancel or initiate the Delays function of the panel, which
is configured during commissioning (refer to 997-263
ID50 Series Panel Installation, Commissioning and
Configuration Manual, Sections 5.5.5.4 Primary/
Extend Delay Timers and 5.7.8 CBE Zones).
To Disable / Enable Delays:
1 Using the numeric keypad, press the '
select the Disable/Enable Delays option:
1:Zone
3:Day Mode 4:Delays
2 At the prompt, press the '
Delays operation. If delays are disabled, the LCD
prompts to enable delays, and vice versa.
to confirm
When the delays are disabled, the DELAY ACTIVE
LED is extinguished. When the delays are enabled,
the LED is illuminated.
1:Zone
3:Day Mode 4:Delays
If a Day Mode time period is configured, the CBE Rule
delays will activate when Day Mode is started either:
a. Using the Disable / Enable menu, or
b. When Digital / ÜE Input 1 is operated (if this input
is configured during commissioning for Day Mode
Start).
These delays will be deactivated when Day Mode is
ended, either automatically at the end of the configured
Day Mode period, or by one of the following:
a. Using the Disable / Enable menu,
b. When the Digital / ÜE Input 1 is operated,
c. Delays are disabled using the Disable / Enable
menu.
33
' button to
4
2:Outputs
' button to confirm the
5
<:Cancel
2:Outputs
997-264-000-8, Issue 8
January 2007