Zones - User Option - Notifier ID50 SERIES Operating Manual

1
3
2
or
2 8
997-264-000-8, Issue 8
January 2007
ID50 Series Panel - Operating Manual

4.9.3 Zones - User Option

The Test Zones option, selected from the Test Menu,
allows the user to perform a walk test on one zone at a
time.
During the walk test the TEST and relevant ZONE
FAULT/DISABLE/TEST LEDs are illuminated, indicating
that the system and zone is in TEST mode. To perform a
walk test, at the TEST menu:
1 Press the '
[U0 Test]
4:Auto High Test
2 The LCD displays the Test Zones menu. Select either
[U0 Zones]
2:No Sounders
a. Using the numeric keypad press '
[WALK TEST (Sounders)]
: Start
i
5
[WALK TEST (Sounders)]
Press
ii The LCD prompts for confirmation. Press the '
[WALK TEST (Sounders)]
: Start
iii Press the '
b. To walk test devices on a specific zone without
22
' button on the numeric keypad to select
3
the walk test procedure.
1:LEDs 2:LCD
5:Outputs
the Ring Sounders or No Sounders walk test:
1: Ring Sounders
3:View/Stop Test
Ring Sounders menu as below. In this mode the
sounders will ring for a few seconds when a device is
tested, then reset automatically.
Select Zone:01
: Change
Use the ' / ' buttons to select the zone to be
2 8
tested. Press the ' ' button to confirm the zone
5
number.
Select Zone: 01
to Confirm
button to start the walk test for this zone. Repeat
steps i and ii for any further zones to be tested. Test
the devices (see Checking the Devices overleaf).
Select Zone: 01
: Change
' button to exit the Ring Sounders menu
4
and return to the Zones menu.
activating the sounders, press '
keypad to select the 'No Sounders' option. The walk
test procedure is otherwise the same as given above
for 'Ring Sounders'.
3:Zones
: More
: More
' to display the
1
<:Exit
<:Cancel
'
5
<:Exit
' on the numeric
2