Power Fail - Notifier ID50 SERIES Operating Manual

If both the AC and
Battery power fail, the
indicators and LCD are
non-operational.
997-264-000-8, Issue 8
January 2007
ID50 Series Panel - Operating Manual
2 If a service contact number has been entered during
panel commissioning, the LCD alternates between the
fault message(s) and the following:
A
FAULT
E
For Service Contact ***** ******
Note: Press the MUTE BUZZER pushbutton to silence
the panel's internal buzzer.
3 When the cause of the fault has been cleared, press
the RESET pushbutton.
Status: NORMAL
Sat 01/12/2001

3.3.1 Power Fail

1 The loss of a power supply causes the panel to enter
a Power Fail condition. The POWER SUPPLY FAULT
and general FAULT LEDs illuminate and the internal
buzzer operates. The LCD displays:
a. Fault condition.
b. Fault number currently displayed.
c. Total number of faults logged.
d. Time fault was logged.
e. A text message describing the fault.
A
FAULT
E
NO MAINS SUPPLY
A battery fault is shown on the LCD as follows:
FAULT
BATTERIES MISSING
2 If a service contact number has been configured, the
LCD alternates between the power fault message and
the service contact number.
Note: Press the MUTE BUZZER pushbutton to silence
the panel's internal buzzer.
3 When the cause of the fault has been cleared, press
the RESET pushbutton.
Status: NORMAL
Sat 01/12/2001
10
B C
01 / 03
00:00:00
B C
01 / 02
01 / 02
00:00:00
D
14:55
D
14:55
14:55