2. Connection to the network
2.1 System requirements
The following equipment is required to connect the projector to your computer
through the network.
■ Common
The projector: 1 unit,
■ Connecting device for the projector and the computer
1) For the wired connection *1
LAN cable (CAT-5e or greater): 1 piece
2) For the wireless connection *2
- Projector side
IEEE802.11b/g/n USB wireless adapter (option : USB-WL-11N-NS): 1 unit *3
- Computer side
IEEE802.11b/g/n wireless LAN equipment: 1 unit for each computer *4
*1: The system for using the network function of the projector requires a
communication environment conforming to 100Base-TX or 10Base-T.
*2: An access point is required when the wireless LAN connection is used as
Infrastructure mode.
*3: Available encryption methods are as follows. This projector cannot be
connected to the wireless network using other encryption method.
WPA2-PSK (AES)
WPA2-PSK (TKIP)
WPA-PSK (AES)
WPA-PSK (TKIP)
WEP 128bit
WEP 64bit
*4: Depending on the type of wireless network device and computer you are
using, the projector may not communicate properly with your computer, even if
the computer is equipped with a built-in wireless LAN function.
To eliminate communication problems, use a Wi-Fi certified wireless network
device.
■ Web browser
Web browser is required to be installed in your computer to use Web control.
■ Application
Exclusive applications are required to be installed in your computer to use
Network Presentation, My Image and Messenger. (&18)
NOTE
• The network function is not available when STANDBY MODE is set
to POWER SAVE and the projector is in standby mode. Connect the projector
to the network after setting STANDBY MODE to NORMAL. (&SETUP menu in
the Operating Guide)
DWU1052/DHD1052
User's Manual - Network Guide
Computer: 1 or more sets
Simple Access Point mode
✓
✓
✓
✓
-
-
11
2. Connection to the network
Infrastructure mode
✓
✓
✓
✓
✓
✓
020-000855-01 Rev.1 (12-2015)
LIT MAN USR DWU/DHD1052 NET