Targets Menu; Target Messages - GE C30 Instruction Manual

TARGETS MENU

With the CyberSentry option, this setting is available to enable or disable the following commands.
ADMINISTRATOR LOGOFF
ENGINEER LOGOFF
OPERATOR LOGOFF
CLEAR SECURITY DATA
operands associated with the self-tests.
7.2 Targets menu
The status of any active targets displays in the targets menu. If no targets are active, the display reads

7.2.1 Target messages

When there are no active targets, the first target to become active causes the display to immediately default to that
message. If there are active targets and the user is navigating through other messages, and when the default message
timer times out (i.e. the keypad has not been used for a determined period of time), the display again defaults back to the
7
target message.
The range of variables for the target messages is described below. Phase information is included if applicable. If a target
message status changes, the status with the highest priority displays.
Table 7-1: Target message priority status
Priority Active status
1 OP
2 PKP
3 LATCHED
If a self test error is detected, a message appears indicating the cause of the error. For example UNIT NOT PROGRAMMED
indicates that the minimal relay settings have not been programmed.
7-4
OPERATOR

LOGOFF: No
CLEAR SECURITY DATA:

No
— Selecting 'Yes' allows the Supervisor to forcefully logoff an administrator session.
— Selecting 'Yes' allows the Supervisor to forcefully logoff an engineer session.
— Selecting 'Yes' allows the Supervisor to forcefully logoff an operator session.
— Selecting 'Yes' allows the Supervisor to forcefully clear all the security logs and clears all the
TARGETS
DIGITAL ELEMENT 1:

LATCHED
DIGITAL ELEMENT 48:

LATCHED

Description
element operated and still picked up
element picked up and timed out
element had operated but has dropped out
Range: Yes, No
Range: Yes, No

Displayed only if targets for this element are active.
Example shown.
Displayed only if targets for this element are active.
Example shown.


C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 7: COMMANDS AND TARGETS
NO ACTIVE TARGETS
.