Custom Led Labeling - GE C30 Instruction Manual

FRONT PANEL INTERFACE
USER-PROGRAMMABLE LEDS
Default labels for LED panel 2
The default labels are intended to represent the following:
• GROUP 1...6 — The illuminated GROUP is the active settings group
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support six
4
setting groups. For convenience of users using earlier firmware revisions, the relay panel shows eight setting
NOTE groups. Even though the LEDs have default labels, they are fully user-programmable.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained in
the next section.

4.2.8 Custom LED labeling

4.2.8.1 Enhanced faceplate
The following procedure requires these pre-requisites:
• EnerVista UR Setup software is installed and operational
• The C30 settings have been saved to a settings file
• The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded from
http://www.gedigitalenergy.com/products/support/ur/URLEDenhanced.doc
• Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1. Start the EnerVista UR Setup software.
2. Select the Front Panel Report item at the bottom of the navigation menu for the settings file. The front panel report
window displays.
4-20
Figure 4-21: LED panels 2 and 3 (index template)
USER-PROGRAMMABLE LEDS
and printed
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
842782A1.CDR