GE C30 Instruction Manual page 92
Controller system
Hide thumbs
Also See for C30:
- Instruction manual (488 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (441 pages)
Table of Contents
Advertisement
ENERVISTA SOFTWARE INTERFACE
4.1.6.1 Enable the settings template
The settings file template feature is disabled by default. The following procedure describes how to enable the settings
template for UR settings files.
1.
Select a settings file from the offline window of the EnerVista UR Setup main screen.
2.
Right-click the selected device or settings file and select the Template Mode > Create Template option.
The settings file template is now enabled and the file menus displayed in light blue. A message displays. The settings file is
now in template editing mode.
Alternatively, the settings template can also be applied to online settings, as follows.
1.
Select an installed device in the online window of the EnerVista UR Setup window.
2.
Right-click the selected device and select the Template Mode > Create Template option.
4
The software prompts for a template password. This password is required to use the template feature and must be at
least four characters in length.
3.
Enter and re-enter the new password, then click OK to continue.
The online settings template is now enabled. The device is now in template editing mode.
4.1.6.2 Edit the settings template
The settings template editing feature allows the user to specify which settings are available for viewing and modification in
EnerVista UR Setup. By default, all settings except the FlexLogic equation editor settings are locked.
1.
Select an installed device or a settings file from the menu on the left side of the EnerVista UR Setup window.
2.
Right-click and select the Template Mode > Edit Template option to place the device in template editing mode.
3.
If prompted, enter the template password then click OK.
4.
Open the relevant settings window that contains settings to be specified as viewable.
By default, all settings are specified as locked and displayed against a grey background. The icon on the upper right of
the settings window also indicates that the EnerVista software is in EDIT mode. The following example shows the
phase time overcurrent settings window in edit mode.
4-4
CHAPTER 4: INTERFACES
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
Advertisement
Table of Contents
