GE C30 Instruction Manual page 160

PRODUCT SETUP
Gen functional ldName
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for the Gen logical device instance, which contains the
UR logical nodes modelling FlexLogic, Virtual Outputs, non-volatile latches, FlexElements, recording (for example
oscillography), security, front panel, and clock.
Location
Range: 0 to 255 ASCII characters
Default: Location
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.location. This data attribute is
provided by the protocol to allow the user to declare where the equipment is installed.
Latitude
Range: -90.000 to 90.000 degrees in steps of 0.001 degree
Default: 0.000 deg
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.latitude. This data attribute is provided
by the protocol to allow the user to declare the geographical position of the device in WGS84 coordinates -latitude.
Negative values indicate a southern latitude. WGS refers to the world geodetic system, which is used in global
positioning systems (GPS), and 84 is the current version of the standard.
Longitude
Range: -180.000 to 180.000 degrees in steps of 0.001 degree
Default: 0.000 deg
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.longitude. This data attribute is
5
provided by the protocol to allow the user to declare the geographical position of the device in WGS84 coordinates -
longitude. Negative values indicate a western longitude.
Altitude
Range: 0 to 10,0000 m in steps of 1 m
Default: 0 m
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.altitude. This data attribute is provided
by the protocol to allow the user to declare the geographical position of the device in WGS84 coordinates - altitude.
Prefix for GGIO1
Range: 0 to 7 VisibleString characters
Default:
This setting sets the LN Prefix of the logical node GGIO1 that is described in the GGIO1 section later. Valid characters are
upper and lowercase letters, digits, and the underscore (_) character. The first character must be a letter.
Prefix for GGIO2
Range: 0 to 7 VisibleString characters
Default:
This setting sets the LN Prefix of logical node GGIO2 that is described in the GGIO2 section later. Valid characters are
upper and lowercase letters, digits, and the underscore (_) character. The first character must be a letter.
Prefix for GGIO4
Range: 0 to 7 VisibleString characters
Default:
This setting sets the LN Prefix of logical node GGIO4 that is described in the GGIO4 section later. Valid characters are
upper and lowercase letters, digits, and the underscore (_) character. The first character must be a letter.
5-42
CHAPTER 5: SETTINGS
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL