8-Bit Switches - GE C30 Instruction Manual

CONTROL ELEMENTS
SETTING
COUNTER 1 FUNCTION:
Enabled = 1
SETTING
COUNTER 1 UP:
Off = 0
SETTING
COUNTER 1 DOWN:
Off = 0
SETTING
COUNTER 1 BLOCK:
Off = 0
SETTING
CNT 1 SET TO PRESET:
Off = 0
SETTING
COUNTER 1 RESET:
Off = 0
SETTING
COUNT1 FREEZE/RESET:
Off = 0
SETTING
5 COUNT1 FREEZE/COUNT:
Off = 0

5.7.5 8-bit switches

SETTINGS  CONTROL ELEMENTS  8-BIT SWITCHES  8-BIT SWITCH 1(6)
 8-BIT
 SWITCH 1
This feature allows switching between two input arguments defined by 8 bits each. The bits are specified by FlexLogic
operands. The feature could be viewed as an integrated two-position switch for 8 logic signals.
Typically this element is applied in conjunction with the Digitizer and 8-bit Comparator features.
5-144
Figure 5-66: Digital counter logic
SETTINGS
COUNTER 1 NAME:
AND COUNTER 1 UNITS:
COUNTER 1 PRESET:
RUN
CALCULATE
VALUE
SET TO PRESET VALUE
SET TO ZERO
AND
AND
OR
STORE DATE & TIME
OR
8BIT SWITCH 1

FUNCTION: Disabled
8BIT SW 1 ARG A0:

Off
8BIT SW 1 ARG A1:

Off

8BIT SW 1 ARG A7:

Off
8BIT SW 1 ARG B0:

Off
8BIT SW 1 ARG B1:

Off

8BIT SW 1 ARG B7:

Off
8BIT SW 1 CONTROL:

Off
CHAPTER 5: SETTINGS
SETTING
COUNTER 1 COMPARE:
Count more than Comp.
Count equal to Comp.
Count less than Comp.
ACTUAL VALUE
COUNTER 1 ACCUM:
ACTUAL VALUES
COUNTER 1 FROZEN:
Date & Time
827065A2.VSD
Range: Disabled, Enabled
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
FLEXLOGIC
OPERANDS
COUNTER 1 HI
COUNTER 1 EQL
COUNTER 1 LO