Table of Contents
Advertisement
About Your Machine
NOTE:
• While the machine is warming up, it can receive or transmit a document, but not print
a document received.
• After completing warm-up, the machine automatically enters the Power Save mode
when the machine is not used for a long time.
• You can set the time it takes to enter the Power Save mode, or turn the mode OFF
through the Utility key.
Turning the Machine power OFF
1. Check that the memory volume display on
the Message Display shows 100%.
If the percentage shown is less than 100%, it means that there are documents stored
in memory which have not been transmitted. In this case, perform the following
steps to retain these documents.
When the memory contains a document to be transmitted:
Output the Memory Image Print, and retransmit at another time.
When the memory contains a document received:
Let the machine print the document received according to the specific procedure as
follows.
Printing the Document Received by Memory RX Mode í P 2-31
Printing the Mailbox Document í P 4-15
2. Turn the power switch to "¡ ¡ " (OFF) position.
Power switch
turn to "¡ ¡ "
JAN.01 15:38
-SET DOC. FACE UP-
1-2
100%
Advertisement
Table of Contents
