Settings For Shipment（出荷設定 - Yamaha TF5 Service Manual

TF5/TF3/TF1
C. ST IN
No. Item
1 Gain
2 Frequency Response
Test Command : STIN
3 THD + N
4 Noise Level
D. PHONES OUT
No. Item
Test Command :
1 Gain
Test Command :
2 Frequency Response
Test Command :
3 THD + N
Test Command :
4 Noise Level
E. Measurement of Analog Mute
Item
Test Command :
Analog Mute
F. Phantom Power Supply
This measurement can be represented by following INPUT channel.
TF5 : INPUT 1,9,17,25
TF3 : INPUT 1,9,17
TF1 : INPUT 1,9
Connect load resistance 10kΩ between pin No.1 and 2. Short pin No.2 and 3 with 0Ω.
If the case of [HAAD_48V_ON]
Confi rm that it is within a range of DC 33.6V ~ 36.1V.
If the case of [HAAD_48V_OFF]
After setting +48V OFF, check discharge starts promptly.
SETTINGS FOR SHIPMENT
● Initialization
Refer "Initialization" the (198 page).
● Knobs Setting
･ PHONES LEVEL
･ FADER
･ POWER Switch
160
Condition Input
ST IN 1 L/R
ST IN 2 L/R
1kHz +10dBV
ST IN 1 L/R
ST IN 2 L/R
1kHz 0dBV
ST IN 1 L/R
ST IN 2 L/R
1kHz +10dBV
Short input with 150Ω
ST IN 1 L/R
ST IN 2 L/R
Condition Input
Internal Oscillator
DA_MAX (Automatically set)
INPUT1,2
DA_AUDIO 1kHz +4dBu
Internal Oscillator
DA_MAX (Automatically set)
Internal -∞
DA_NOISE (Automatically set)
Condition Input
Internal Oscillator
DA_AMUTE (Automatically set)
: Min. (Full C.C.W. position)
: Min. (-∞)
: OFF
Output
+24.0 ± 2.0 dBu
1kHz : 0dB (reference)
20Hz : -0.5 ± 1.0 dB
20kHz : -0.5 ± 1.0 dB
OMNI OUT 1-4
≦ 0.02 %
≦ -77 dBu
Output
+9.0 ± 1.0 dBu
1kHz : 0dB (reference)
20Hz : -0.5 ± 1.0 dB
20kHz : -0.5 ± 1.0 dB
PHONES L/R
≦ 0.05 %
PHONES LEVEL
Max : ≦ -79 dBu
Min : ≦ -93 dBu
Output
OMNI OUT 1-16 ≦ -23 dBu
PHONES L/R ≦ -23 dBu
Criteria Remarks
80kHz LPF
22kHz LPF
Criteria Remarks
80kHz LPF
22kHz LPF
Criteria Remarks