Transmitting Parameter Settings Via Midi (Bulk Dump); Category Section; Request - Yamaha O1V 96 Service Manual

TRANSMITTING PARAMETER SETTINGS VIA MIDI (BULK DUMP)

You can back up data stored in the 01V96, such as libraries and Scenes, to an external MIDI device by using MIDI Bulk
Dump. In this way, you can later restore previous 01V96 settings by transmitting this MIDI data back to the 01V96.
Note: Some of the data transmitted from the 01V96 to the sequence software may occasionally drop out during Bulk
Dump transmission. To avoid this, we recommend that you use the included Studio Manager software to store 01V96
data to an external device.
1 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the DIO/Setup | MIDI/Host page appears, then
specify ports for transmission and reception of MIDI messages.
2 Make connections using the ports selected in Step 1 so that the 01V96 can transmit and receive MIDI messages to
and from the external device.
3 Press the DISPLAY ACCESS [MIDI] button, then press the [F4] button.
The MIDI | Bulk page appears.
The page includes the following parameters:
q CATEGORY section
This section enables you to select data for transmission and reception.
w REQUEST
Move the cursor to this button, then press [ENTER] to transmit messages from the 01V96 that request a second 01V96
(connected to the first 01V96) to transmit the data specified in the CATEGORY section. This button is used primarily when
two 01V96s are connected in cascade.
e TRANSMIT
Move the cursor to this button, then press [ENTER] to transmit data specified in the CATEGORY section to an external MIDI
device.
r INTERVAL
This parameter specifies the interval between data packets during bulk transmission in 50 millisecond steps. If the external
device drops part of the bulk data, increase this parameter value.
4 In the CATEGORY section, move the cursor to the button of the data type you want to transmit, then press [ENTER].
Downloaded from www.Manualslib.com manuals search engine
01V96
115