Test Program（テストプログラム - Yamaha TF5 Service Manual

TF5/TF3/TF1
TEST PROGRAM
1. Preparation
Activating TF5, TF3, or TF1 in test program mode will change the settings and parameters in TF5, TF3, and TF1, enabling tests
of the TF series.
2. Measurement Environment
Normal Temperature: 5 to 40 degree, Normal Humidity: 30 to 90%
Note) The following measurement conditions are permitted if the measurement result is in the inspection
standard.
Temperature: 5 to 40 degree, Humidity: 20 to 90%
But, measure it again at the normal temperature and normal humidity when it varies from the inspecting standard.
3. Power Supply
Power supply voltage and frequency should be within the range of Table 1.
Table 1 :
Voltage
100V-10% to 230V+10%
4. Required items
･ Object to be checked TF5/TF3/TF1 itself.
･ PC (Yamaha Steinberg USB Driver installed) (Used in ETHER test, USB_TO_HOST test and when a command is sent)
･ Ethernet cable (Used in ETHER test and when a command is sent)
･ USB memory (Used in USB_CONNECT and IPOD_CONNECT)
･ USB cable (Used in USB_TO_HOST test)
･ FOOT SW (YAMAHA FC4 or Jig) (Used in FSW test)
･ XLR cable (OMNI OUT Terminal → INPUT Terminal) 4 pcs, RCA − Stereo standard pin x2 (PHONES L/R OUT → ST IN
1/2 L/R ) 2 pcs (Used in AIN/AOUT test)
5. Power Supply
Download the fi rmware and driver from the YSISS home page.
･ Firmware
･ Yamaha Steinberg USB Driver
For the updating procedure, refer to the "FIRMWARE (HOST CPU AND OTHER SUB CPU) UPDATER BY USB MEMORY"
section on page 199.
128
Frequency
50 or 60Hz