Added Support For Remote Operation Of The Mmp1 (Nuage Fader, Nuage Master, And Nuage Workgroup Manager); Settings (Preparations) - Yamaha NUAGE MASTER Ncs500-CT Operation Manual

Added support for remote operation of the MMP1
(Nuage Fader, Nuage Master, and NUAGE Workgroup Manager)
Certain MMP1 functions can be controlled from the Nuage series.

Settings (Preparations)

Set the control source to Nuage Fader and/or Nuage
Master and the control target to MMP1 with the NUAGE
Workgroup Manager.
1.
Open NUAGE Workgroup Manager.
2.
Click "Setup."
4. Select a MMP1 you will control remotely.
NOTE
When you remove the check mark in step
3.
Set the IP address.
To control MMP1 from the Nuage Fader and/or Nuage
Master, the IP address of the Nuage Fader and/or the
Nuage Master must be set in the same subnet as
MMP1.
For details about IP address settings of the MMP1,
refer to the MMP1 Getting Started and MMP1
Operation Manual documents.
Click the desired tab of the Nuage Fader or
Nuage Master as a control source, and then
set the IP settings.
IP address settings for the Nuage Fader and Nuage
Master depend on the IP address settings of the MMP1.
1 Select the "MMP1" tab,
2 Check the check box,
3 Select an MMP1 to control.
4 When a Passcode is set for the MMP1,
2
, the keys on the Nuage Fader and Nuage Master return to conventional behavior.
enter the Passcode.
Added functions in NUAGE V2.0 53