Yamaha TF5 Service Manual page 131

q [Version] display
The version of the program and MAINCOM circuit board is displayed.
The version display of PNFD and HA will be the display which changed as follows with circuit board composition for
every model. (The example of V1.00)
<TF5> PNFD : V1.00 V1.00 V1.00 V1.00
HA : V1.00 V1.00 V1.00 V1.00
<TF3> PNFD : ----- V1.00 V1.00 V1.00
HA : V1.00 V1.00 V1.00 -----
<TF1> PNFD : -----
HA : -----
w [MAC address] display
The MAC address of a Network connector is displayed.
Un-writing in and when inaccurate (the vendor ID section is not YAMAHA), it is displayed as "--:--:--:--:--:--".
e [IP address] display
IP MAC address is displayed.
r [Product type] display
Product type is displayed. (TF5/TF3/TF1 )
If the model type has not been set up, it is displayed as "------".
t [TOTAL] button
The screen for product test starts.
y [MAINCOM] button
The screen for MAINCOM circuit board assembly test starts.
u [HACOM] button
The screen for HACOM circuit board assembly test starts.
i [PNFDCOM] button
The screen for PNFDCOM circuit board assembly test starts.
o [PNCOM] button
The screen for PNCOM circuit board assembly test starts.
!0 [FADER IQC] button
The same program as a "Fader IQC application" starts on the screen of a main part.
(For use in factory inspection, not used during service.)
!1 [FADER Calibration] button
The screen for "Fader Calibration" functions starts. ("FADER CALIBRATION" See page 194).
!2 [MEASUREMENT SUPPORT] button
The screen for "MEASUREMENT SUPPORT" functions which supports measurement inspection starts.
("7-16. MEASUREMENT SETTING" See page 156).
!3 [EXIT] button
The test program mode is terminated and it starts by the normal mode.
!4 [Initialize] button
Backup memory is initialized as a default. ("INITIALIZE" See page 198).
----- V1.00 V1.00
----- V1.00 V1.00
TF5/TF3/TF1
131